ADDITIONAL FEATURES

Product Gross Weight: 0.9500 lb
Product Net Weight: 0.9500 lb
Product Height: 2.50 in
Product Length: 11.63 in
Product Width: 6.81 in

INSTRUCTIONS

Use Instructions: Carefully inspect new heater for signs of damage. Pay close attention to heating element and glass casing around heating element. If damage is observed or suspected, DO NOT USE. Contact Zoo Med’s customer service department.HEATER INSTALLATION:With the heater unplugged, perform the following steps to install your new TURTLETHERM™ heater.1. Rinse new heater under running water before placing in your aquatic turtle habitat.2. Select the ideal location on the side or back wall of the habitat. Heater must be fully submerged in water. Check to make sure that the suction cups are securely attached to the wall of the habitat.3. If possible, place the heater near the filter outlet to improve circulation of heated water and to achieve even heating throughout the habitat.4. Allow heater to acclimate to the water temperature for 20 minutes before plugging in.HEATER OPERATION:1. After performing the installation steps above, plug the heater into an appropriate GFCI outlet.2. When plugging the heater in, the preset temperature of 78 degrees will flash briefly on the display. After a few seconds, flashing will stop and the actual water temperature will then be shown on the display.3. When heating, the red indicator light next to the words “ON/OFF” will illuminate. Shortly after reaching the preset temperature of 78 degrees, the heating element will automatically turn off and the indicator light will go out. Heating will resume and the indicator light will turn on when the temperature drops below 78 degrees.SAFETY SHUT-OFF:1. This heater is equipped with a safety shut-off feature that turns the heating element off if the heater is exposed to air. If the heater accidentally comes out of the water, or if the water level drops below the level of the heater, the heating element will shut-off and “E1” will flash on the display.2. Normal operation will resume when the heater is again submerged completely in water. Be sure to maintain the appropriate water level in the habitat to prevent this from occurring.3. Periodically check to make sure that the suction cups are securely attached to the side or back wall of the habitat to prevent the heater from coming out of the water.

SAFETY

Caution: Keep children and household pets (other than your aquatic turtle(s) away from heater
Safety Warnings: Caution must be taken when using electrical appliances in water. To reduce the risk of injury or electric shock, be sure that the heater is unplugged during any of the following situations:1. Unplug when installing the heater in your aquatic turtle habitat.2. Unplug when performing habitat maintenance.3. Unplug before placing your hand(s) in the water of the aquatic turtle habitat. Be sure that your hands are completely dry before plugging the heater into an appropriate electrical outlet.4. Unplug when not in use.5. When unplugging the heater, grasp the plug to prevent damage to the power cord. Never pull on the power cord to unplug the heater.6. DO NOT splice, repair, or modify the power cord. Inspect the power cord periodically for damage.7. Plug heater into GFCI protected outlet and incorporate a drip loop as described in these instructions.8. If an extension cord is necessary, be sure to use a cord with the appropriate electrical rating.9. The heating element inside this heater is encased in glass. Inspect glass periodically for signs of damage or breakage. Discontinue use immediately if damage is observed or suspected.10. Unplug heater and allow it to cool before removing it from water for any reason.11. For indoor use only.12. For use in water with aquatic turtle habitats only.13. Turtles can mistake various objects for food. If you observe your turtle attempting to bite or chew any part of the heater, including but not limited to the power cord, unplug and discontinue use immediately. If you suspect that your turtle is biting or chewing on the heater, unplug and discontinue use immediately.14. DO NOT alter or modify this product. Contact an electrician if you are unsure about the electrical connection.

WARRANTY

Warranty Description: 1 Year Warranty

SPECIFICATIONS

Compatible Tank size: 50 Gallons
Wattage: 150 Watts

Automatic preset aquatic turtle heater features 50 watts for heating up to 15 gallons of water. Preset: Simply attach to the inside wall of your turtles enclosure and plug in. The TURTLETHERM will warm the water to 78'F (26'C). SAFETY: The TURTLETHERM will automatically shut off if removed from water. APPLICATIONS: For use in aquatic turtle habitats with up to 15 gallons of water*. (*For use in 15 gallons of water. Heater must be fully submerged.) Mount on side or back of aquatic turtle habitat using enclosed suction cups. Fully submerge heater in water before plugging heater in electrical outlet. Safety shut-off activates if removed from water. Allow 1-3 hours for water to reach the target temperature. Place heater near the filter outlet to improve circulation of warm water.

Country

Country

Zoo Med Turtletherm Automatic Preset Aquatic Turtle Heater 1ea/150 W